Daily/Weekly Shower Maintenance
- 1Always squeegee walls and glass after showering.
- 2Leave shower door open to let humid air escape and turn on exhaust fan if possible.
- 3
Spray shower walls down with Easy Oxy. Scrub with a soft bristle brush or soft sponge. Buff dry with microfiber towel or rinse walls then squeegee the walls.
Do’s
- Use liquid soap instead of bar soap to minimize soap scum buildup on shower walls and floor
- Dry the shower after each use to prevent mildew growth
- Leave the shower door open after use to allow proper ventilation and reduce mildew risk
- Keep the shower drain clear of buildup
- Check that the weep holes in the drain are unblocked so the shower pan can drain properly
Dont’s
- Don’t use bar soap if you want to avoid excessive soap scum accumulation
- Don’t leave the shower wet after use
- Don’t keep the shower door closed immediately after showering
- Don’t allow hair, debris, or buildup to clog the drain
- Don’t ignore blocked weep holes in the drain, as this will cause water retention and mildew growth
Monthly Shower Maintenance
Dilute and then spray natural stone or ceramic or porcelain tile walls and floors with MB-3 Soap and Mineral Deposit Remover. Let it dwell for 1-2 minutes. Rinse areas then squeegee or dry with towels.
Spot treat mold or mildew with Mb-9 Mold and Mildew Remover. Let it dwell then use a soft bristle brush to scrub the area if necessary. Rinse then dry the area.
Use Easy Scrub and a white pad to any hard water off glass. Always test in a small area to make sure your glass does not have a coating. Put Easy Scrub on the white pad and work in small areas, buff until hardwater is removed. Then clean the glass with Easy Oxy and a microfiber towel.
Use MAAS Metal Polish and microfiber towel to clean fixtures. This will help keep water spots to a minimum.
Book a Professional Clean
If routine maintenance isn’t enough, a professional tile and grout cleaning service can deep clean your shower surfaces and bring back their original brightness.
